|Sensors and accessories for Logger 2020 and our wide range of sensors.|
Temp pocket in stainless steel 1/2 ". Temp pocket in stainless steel. Temp pocket suitable for e.g. solar panels or in installations where a certain mechanical wear can occur. The actual temp pocket in contact with the media is AISI 316Ti and the "head" is in AISI 303 Fits our temperature sensors with 6 mm protective sleeve over the temperature sensor.
Compression fitting for temp sensors Smooth compression fittings for mounting temperature probes with 6 mm sleeve (see picture). This compression fitting allows you, via a T-pipe coupling, to plug in your temp sensor directly in the flow of the liquid you are measuring the temperature of.
Compression fitting 1/4" Smooth compression fittings for mounting our temperature probes with 6 mm protective cover (see picture). This compression fitting allows you to, via a a T-pipe coupling, plug in your temp sensor directly in the flow of the media you are measuring the temperature of.
Electricity meter sensor Sensor reads flashing from IR or UV diodes, particularly for use with the Logger 2020. Simply attach these sensor via 2-lead wire to Logger 2020:s E1 or E2 terminals in order to monitor energy and power consumtion.
Electricity meter sensor Sensor reads the flashing of IR or UV diodes, particularly for use with Logger 2020 and SunLogger 2020 monitoring units. The sensor is easily connected with a two-core cable to the Logger 2020 or SunLogger 2020 input terminals E1 and/or E2.
LED INDICATOR, 230V, RED This 230 V LED indicator can be used as a status indicator for compressors, circulation pumps, motors, etc., in combination with our "Light sensor 230 V" is it possible, by Logger 2020's I/O-module A/DMIQ show operating status of the objects the indicator is connected to.
Light sensor Three-wire lightning to voltage converter, the sensor are adapted to the Logger 2020's A/DMIQ I/O-module, and can be used both as analog sensor to the analog inputs, and for indicatiing status of measured diods/lamps indication service status - on the digital inputs of the A/DMIQ -module.
Heat conductive paste 3 ml This paste is great to use when installing a temp sensor to pipes, tanks or in temp pockets. A small amount of paste is enough to improve the measurement accuracy, particularly in terms of reaction times during sudden temperature changes.
Ethernet cable Unshielded cabling consisting of a 4-pair cable, Category 5e (Cat 5e), and an RJ45 connector on both ends. This cable are needed to connect Logger 2020 to your router if you want to run your Logger 2020 against the web service e-logger.se - or if you need to update the software in your Logger 2020.Select cable length before adding to cart.